Board
Fit and height
Raise this for a shield, HAT, or a tall cooler.
Walls and material
Lid window / display
A cutout in the lid for a display, an LED matrix, or a window. Position is from the lid centre.
Recess pocket: a blind rectangular recess milled into the lid top with the CSG engine (for a label or an inset). Set width to 0 for none.
Lid text
Wall text
A raised legend on the outside of a wall. Recessed wall text needs boolean carving and is not in this version.
Cooling and access
Case mounting
The DIN cradle snaps on with a flex. The sprung latch uses thinner lips with a snap lead-in; print in PETG or ABS and tune with the coupon.
Needs a thicker wall to leave solid lips either side of the channel. Skipped with a warning if the wall is too thin. A matching bead is added to the lid underside to seat into the channel.
Cable entry
Round holes sized for cable glands, with an optional zip-tie strain-relief saddle just inside the wall. Offset is from the centre of the wall.
Connectors
Toggle a port on or off, and edit its offset along the wall, its height above the PCB, and its cutout size. Values are typical starting points; measure your board and adjust, then save the project. Offset is measured from the centre of the wall.